Often asked: How To Build A Garden Wall With Blocks?

Which blocks for a garden wall?

Concrete blocks can be used by laying them side by side, again with mesh ties holding the two sections together, or by laying them flat to give either a 225mm wide wall, or long ways to give a 450mm wide wall. There are also proprietary products for building strong walls and one of these is the hollow concrete block.

What is the easiest retaining wall to build?

For the average do-it-yourselfer, building a retaining wall is easiest when using masonry blocks that will be stacked no taller than three feet, with no mortar binding the stones or concrete members. (For a curved wall, mark instead with a garden hose or spray paint.)

What is the cheapest type of retaining wall?

What is the cheapest retaining wall material?

  • Treated pine and is the least expensive material.
  • Hardwood is more expensive than treated pine.
  • Railway sleepers are another – slightly more expensive – option and are built to withstand ground and water contact.
  • Concrete sleepers are more expensive.
You might be interested:  Readers ask: How To Make A Fire Wall?

How deep should a footing be for a block wall?

The first step in building a block wall is pouring a concrete footing for the blocks to rest on. The footing has to be below frost line and as level as you can make it. For a foundation wall with 7 courses (rows) of block, the footing was 30 inches below grade, 24 inches wide and 12 inches deep.

Do you need footings for a garden wall?

You should always build a garden wall on a solid foundation of a trench filled with concrete. This is called the ‘footing‘, and if it’s substantial and accurate, your wall will last longer and be easier to build.

Is it easy to build a garden wall?

Building a garden wall is a little daunting for some people but it is not a difficult job if you take your time and follow a few simple basic instructions. Firstly a garden wall foundation must not be taken lightly. See our project on mixing concrete to get the correct mix for your foundation.

Do I need a drain pipe behind retaining wall?

Any reinforced wall or walls over 4 ft. (1.2 m) in height or with slopes or other surcharges above the wall will need a toe drain. In all cases wall rock is located within the cores of the block and a minimum of 12 in. (300 mm) behind the block.

What type of retaining wall is best?

Timber and inter-locking-concrete-block walls are great DIY retaining wall ideas. Mortared masonry and poured concrete ones are usually best left to a mason.

What is the best base material for retaining wall?

Due to soil erosion, your retaining wall should be built on a solid foundation made from gravel.

  • Choose gravel that has stones sized between 1/2-inch and 3/4-inch.
  • Fill the trench with a 2- to 3-inch layer of gravel.
  • Use a rake to ensure the stones are evenly distributed.
You might be interested:  How To Grout River Rock Wall?

What can I do instead of a retaining wall?

Reinforced soil slopes are the most cost-effective retaining wall alternatives. Often times you are using the soil that you already have on hand and do not need to bring in any additional.



  • Reinforced Soil Slopes.
  • Natural Stone Walls.
  • Wooden Timbers.
  • Gabion Walls.
  • Soil Bioengineered Walls.

How many retaining wall blocks do I need?

To estimate how many blocks you’ll need per row, divide the total length of the wall by the length of the block. To figure out how many rows you’ll need, divide the ideal wall height by the height of the block. Make sure to account for the first row being half-buried.

HOW MUCH DO Retaining wall blocks cost?

The cost of retaining wall materials ranges from $3 to $40 per square foot. Wall block prices fall between $10 and $15 per square foot, while precase, poured concrete runs $20 to $25. Wood falls in the middle at $15 to $25 per square foot. The final cost depends on the material used and the size of the wall.

Do you need a footing for a cinder block wall?

A: To construct a block wall, you need to establish a solid footing that is a minimum of twice the width of the concrete block. For example, a typical 8x8x16-in. block would require a 16-in. wide footing and extend below the frost line.

Should concrete blocks be filled?

The concrete blocks that are used to build block foundations are hollow. After the concrete blocks are laid, the voids can be filled with a cement-based mortar or poured concrete that contains small pea gravel.



Do you need to fill cinder blocks with concrete?

You might be interested:  FAQ: How To Regrout Shower Wall Tile?
Block Wall Thickness Blocks Filled per Cubic Yard Concrete/Grout per 100 Block
12″ 65 1.54 yd3

Can you use concrete blocks for footings?

Ensure a solid footing. Footings should be a minimum of twice the width of the concrete block (i.e., a typical 8x8x16 block would require a 16-inch wide footing) and extend below the frost line. NOTE: it is important to check local building codes for construction requirements in your area.

Written by

Leave a Reply