- 1 Can you cut molding on the wall?
- 2 What tool do you use to cut baseboards?
- 3 How do you attach molding to a wall?
- 4 Can you nail trim into drywall?
- 5 What is the best way to cut baseboards?
- 6 What is the best saw for cutting trim?
- 7 Should baseboards be caulked?
- 8 Should there be a gap between baseboard and floor?
- 9 What causes baseboards to pull away from wall?
- 10 Are baseboards worth replacing?
- 11 Can you just glue baseboards?
Can you cut molding on the wall?
If the baseboard is thin or made from soft wood, such as pine or cedar, you can cut it by hand. Score the baseboard carefully with a utility knife along the cut line. Once the baseboard is cut, you can use a flat bar and a hammer to tap the section you want to remove away from the wall.
What tool do you use to cut baseboards?
The handiest tool is a miter saw. A miter saw will help you quickly and accurately cut trim. Most importantly, it makes quick work of cutting the corners on baseboard moulding.
How do you attach molding to a wall?
- Locate and lightly mark the wall studs.
- Measure the distance between two inside corners and cut a piece of moulding to fit between the corners.
- Continue installing pieces until all the moulding is up.
- After all the moulding is up, touch up any raw edges with a light coat of finish.
Can you nail trim into drywall?
Use trim nails that will penetrate at least 1/2 inch into the studs. To choose the right-sized nail, add to that 1/2 inch the thickness of the drywall, usually 1/2inch, and the thickness of the trim board. Standard finish nails usually work fine. However, many carpenters prefer to use galvanized finish nails.
What is the best way to cut baseboards?
Using a miter box or a power miter saw, cut the baseboard at a 45-degree angle. Before nailing it in place, mark the second piece the same way, and test for fitting. Use 1-1/4″ or 1-1/2″ brads to close the corner.
What is the best saw for cutting trim?
A power miter saw is the best way to cut crown moulding once you measure the angles. The saw can be adjusted to cut at any angle – set it to 45 degrees for one side of a standard 90-degree corner. The saw can be set to 45 degrees to the left or 45 degrees to the right.
Should baseboards be caulked?
Caulk on both the top and bottom edge of the baseboards closes the gaps to keep the bugs out. It’s more effective, cheaper, easier, and safer than hassling with insecticide sprays and powders to protect your walls. Aesthetics are another good reason to caulk.
Should there be a gap between baseboard and floor?
Gaps on your floor are the last things you would wish to deal with especially if you have a heating system. Gaps between baseboards and laminate floors are just unattractive and can affect your entire house cooling and heating system.
What causes baseboards to pull away from wall?
Baseboards pull away from the walls for many different reasons. Thankfully, most of the time, the pulling is occurring either because of faulty installation, the shifting of the house, warping boards, or shrinking caulk.
Are baseboards worth replacing?
Designed to hide the seam where wall meets floor, baseboards give any room a finished look. If your trim is showing wear and tear, painting is always an option, but the prep work is important and can be time-intensive. Replacement is your best option if they’re water-damaged, stained or warped.
Can you just glue baseboards?
A construction adhesive like Loctite Power Grab Molding and Paneling Construction Adhesive is suitable for installing baseboards.