Quick Answer: How To Construct A Retaining Wall?

Can I build a retaining wall myself?

While retaining walls taller than four feet should be engineered by professionals, you may be able to DIY a solution for a tall slope by creating two or more shorter “tiered” retaining walls as opposed to a single tall wall.

What is the easiest retaining wall to build?

For the average do-it-yourselfer, building a retaining wall is easiest when using masonry blocks that will be stacked no taller than three feet, with no mortar binding the stones or concrete members. (For a curved wall, mark instead with a garden hose or spray paint.)

How do you build a retaining block wall?

  1. mark placement of retaining wall. Mark the Placement of the Retaining Wall.
  2. prepare base for retaining wall. Prepare the Base.
  3. check level and alignment of all blocks. Lay the First Course.
  4. install drainage pipe. Install the Drainage Pipe.
  5. fill concrete cores with crushed gravel.
  6. top final course with capstone blocks.

How deep should the footing be for a retaining wall?

Concrete retaining wall footing size

The depth to the bottom of the base slab should be kept at a minimum of two feet. However, it should always be below the seasonal frost line, and that often is much deeper in northern climates.

You might be interested:  Readers ask: How Far Does A Pool Table Need To Be Away From The Wall?

Do I need drainage behind retaining wall?

Third, since most retaining walls are impervious, which means water cannot pass through the wall itself, efficient drainage is crucial. When drainage goes unaddressed hydrostatic pressure will build up behind the wall and cause damage such as bulging or cracking.

What is the cheapest type of retaining wall?

What is the cheapest retaining wall material?

  • Treated pine and is the least expensive material.
  • Hardwood is more expensive than treated pine.
  • Railway sleepers are another – slightly more expensive – option and are built to withstand ground and water contact.
  • Concrete sleepers are more expensive.

What type of retaining wall is best?

Timber and inter-locking-concrete-block walls are great DIY retaining wall ideas. Mortared masonry and poured concrete ones are usually best left to a mason.

What can I use instead of a retaining wall?

Reinforced soil slopes are the most cost-effective retaining wall alternatives. Often times you are using the soil that you already have on hand and do not need to bring in any additional.

  • Reinforced Soil Slopes.
  • Natural Stone Walls.
  • Wooden Timbers.
  • Gabion Walls.
  • Soil Bioengineered Walls.

How high can you build a retaining wall?

Gravity walls can be small (under 4-feet high) or go upwards to ten feet without reinforcement. Municipalities usually require a building permit for walls taller than 4 feet.

When should you build a retaining wall?

You Might Need a Retaining Wall If…

  1. You need a way to control downhill erosion. If mountains of erosion materials are clogging important areas on your property, adding a retaining wall is a wonderful idea.
  2. Your home is downhill from soil fault lines.
  3. Your foundation is threatened by a sliding hill.
You might be interested:  Quick Answer: Which Condition May Cause Hypoxia Due To Decreased Movement Of The Chest Wall?

HOW MUCH DO Retaining wall blocks cost?

The cost of retaining wall materials ranges from $3 to $40 per square foot. Wall block prices fall between $10 and $15 per square foot, while precase, poured concrete runs $20 to $25. Wood falls in the middle at $15 to $25 per square foot. The final cost depends on the material used and the size of the wall.

What slope requires a retaining wall?

What is the slope? If the slope is greater than a 3:1, consult with an engineer. If the slope is over 2:1, it will require structures or special stabilization techniques.

Written by

Leave a Reply