Quick Answer: How To Fix Hole In Concrete Wall?

How do you repair a hole in a foundation wall?

Repair for Tiny Holes and Cracks

  1. Using a wire brush, brush clean the cracks and the holes.
  2. Le the hole or the crack dry for quite some time.
  3. Fill the cracks and holes with concrete caulk.
  4. If the hole or crack is too big for concrete caulk to deal with, there are patching materials available.

How do you fill a large hole in concrete?

  1. Using a Chisel, Make the Crack Wider at the Bottom than the Top.
  2. Clean Out the Debris with a Stiff Fiber or Wire Brush.
  3. Fill the Crack with Patching Mix (also know as Vinyl Concrete)
  4. Address Any Pop-Outs.
  5. Wet the Surface and Apply a Concrete Bonding Agent.
  6. Pack a Small Amount of Anchoring Cement into the Hole.

What is the best basement waterproofing sealer?

Best Basement Waterproofing Sealer

  • Lithi-Tek 9500. Waterproofer & densifier.
  • Siloxa-Tek 8500. Penetrating water & salt repel.
  • Lithi-Tek 4500. Concrete densifier & hardener.

Does Flex Seal work on basement walls?

Flex Shot and Flex Seal Liquid are great options for attacking a basement wall leak. Pour the Flex Seal Liquid into any larger cracks, then you can use a roller or brush to cover larger areas. Be sure to apply several coats and cover the area as much as you can. For best results, allow 24 hours for each coat to dry.

You might be interested:  FAQ: How To Install Wall Tiles In Bathroom?

Can you seal a basement from the inside?

Apply a masonry waterproofing product to the walls



Seal/coat the interior of the walls with a suitable masonry waterproof product. When the paint dries, the sealant forms a watertight bond to stop water from seeping through. This is how you can waterproof your basement walls from inside.

Can you pour concrete directly on dirt?

Long story short, yes you can pour concrete over dirt.

What do you use to patch concrete?

QUIKRETE Vinyl Concrete Patcher or QUIKRETE Concrete Patching Compound may be used.

  1. Clean the surface of the damaged area by removing any loose material such as dirt, oil, or grease and unsound or flaking concrete.
  2. Scrub and clean the surface of the repair area with a stiff bristle brush.

Written by

Leave a Reply