- 1 How do I put a wall between ceiling joists?
- 2 Do ceiling joists line up with wall studs?
- 3 Can you hang drywall parallel to joists?
- 4 Do I need blocking between joists?
- 5 Do ceiling joists need blocking?
- 6 Which way do ceiling studs run?
- 7 How much weight can a ceiling joist hold?
- 8 How do you hang a stud wall on a ceiling?
- 9 Is it better to hang drywall vertical or horizontal?
- 10 How far apart should the screws be when hanging drywall?
- 11 How much gap should be between sheets of drywall?
How do I put a wall between ceiling joists?
Install each block between the center joists. Place one every 12 inches along the opening length and one at either end. End blocks should extend about 1 inch past the wall, unless there’s an adjacent wall, to allow sheathing and wall anchoring. Tap the blocks to get them in place; it will be a snug fit.
Do ceiling joists line up with wall studs?
Unless they are exposed as architecture details, structural ceiling beams — called joists — are hidden by paint and plaster. Joists are usually spaced at the same intervals as studs — 16 or 24 inches apart.
Can you hang drywall parallel to joists?
You always want to put your drywall perpendicular to the supports. If the supports that are there now are running the way you want to run the drywall, you can strap the ceiling perpendicular to the joists and then run your drywall the way you want it, which would be parallel to your joists.
Do I need blocking between joists?
There must be blocking where joists overlap over a center beam and every eight feet for 2×10 and taller joists. A good rule of thumb is to think if the distance between any two rows with blocking is more than eight feet, you must add some more blocking there.
Do ceiling joists need blocking?
Rafters and ceiling joists having a nominal depth-to-thickness ratio exceeding 5:1 (e.g., 2×10) need blocking at their points of bearing to prevent them from rotating or displacing laterally from their intended position.
Which way do ceiling studs run?
An important thing to know about joists is that they usually run in the same direction throughout a house. If the visible joists in a basement or attic run east to west, for example, you can be fairly certain the invisible joists under the bedroom floor also run east to west.
How much weight can a ceiling joist hold?
Regular garage ceiling joists of modern construction can generally support 50lb/sqft. If you have trusses or your joists are supporting more than just sheetrock or your garage is older this number could be significantly less. Remember to spread the load ACROSS your joists and not along them.
How do you hang a stud wall on a ceiling?
Cut your bottom and top plates and mark the position of the studs. Have a helper hold the top plate against the ceiling while you nail or screw into ceiling joists along the line. Attach the bottom plate to the floor directly below the top plate. Measure the distance between the two plates.
Is it better to hang drywall vertical or horizontal?
On commercial jobs, fire codes often require seams to fall on the entire length of the framing, so the drywall must be hung vertically. For walls nine feet high or shorter, hanging the drywall horizontally has a number of benefits. Fewer seams. Horizontal hanging reduces the lineal footage of seams by about 25%.
How far apart should the screws be when hanging drywall?
Start screwing the drywall to the wall studs (Image 4), sinking each screw below the surface of the drywall, spacing the screws 12 to 16 inches apart.
How much gap should be between sheets of drywall?
Unfortunately, there is no retroactive fix. However, during installation, be diligent about keeping that 1/8-inch space between sheets by using a guide. The blade of a drywall square is about 1/8-inch thick and does the trick. Thin strips of wood can also be used as spacing guides.