Quick Answer: How To Install Pegboard On Wall?

How far should pegboard be from the wall?

Pegboard needs about 1/2 in. of ‘standoff’ space behind it so the hooks can be inserted. Plastic and metal pegboard panels have this space built in, created by the L-shape flanges at the edges.

Can you Mount pegboard on drywall?

Pegboard goes up pretty easily and can be installed over drywall or even bare studs (such as in an unfinished garage). The trick to installing it is to create a 1/2-inch or larger gap between the wall and the back of the pegboard.

How do you hang pegboard on drywall?

  1. Use a stud finder or other means to locate the studs behind the drywall.
  2. Using a level to ensure a 90-degree angle, hold the pegboard in place on the wall – you may need a friend to assist.
  3. Drive screws through pegboard and furring strips at all four corners, aligned with the studs, to leave marks for pilot holes.

Can you hang a pegboard with Command Strips?

Prepare the command strips.



I recommend that you use the 16 lb Command strips to hang your IKEA pegboard. Separate strips by tearing the pieces apart, do not fold. Line up two strips and click them together. You‘ll need six sets for the bar and one set for each spacer.

You might be interested:  FAQ: How To Change Batteries In Honeywell Wall Thermostat?

How much weight can pegboard hold?

How much weight can a pegboard hold? According to a quick search on google, a pegboard can hold 100 pounds if properly installed.

Are furring strips necessary?

Whether it’s the ceiling or the walls, furring strips are essential to ensuring that you’ll always get a flat and smooth surface when the project is complete. When applying furring strips to your walls, they will have to be directly screwed or nailed into the wood or concrete wall.

Is pegboard toxic?

Yes, pegboard can be dangerous. Fiberboard pegboard contains formaldehyde. Pegboard manufacturers use urea-formaldehyde spray adhesive. Fiberboard can be dangerous if it is still out gassing.

Will Home Depot cut pegboard?

Home Depot does cut your wood, or pegboard, or whatever else you need. Measure and mark the pegboard for the correct length and width. Cut the pegboard, following your measurement marks, using a circular saw, jigsaw or table saw.

How big are Pegboard holes?

Pegboard holes come in two sizes: either the larger 9/32 inch holes or the smaller 3/16 inch holes. The larger 9/32 holes are for accommodating 1/4 inch peg hooks but can also hold the smaller 1/8 inch peg hooks.

How do you keep Pegboard hooks from falling out?

To ensure hooks won’t fall out of your board, you have 4 options:

  1. Get the perfect hooks with double peg attachment and appropriate thickness for your board.
  2. Use metal wire to secure thin hooks.
  3. Use glue or a zip tie to secure the thin hooks to your board.
  4. Use plastic peg locks.
You might be interested:  Often asked: How To Save Wall Decals?

Can you paint pegboard?

Instead, go for a solvent-based primer, such as Zinsser or XIM. Once your pegboard is primed and sealed off properly, you‘re good to use your favorite water-based or non water-based paint to finish off painting your pegboard. When painting pegboard, I would advise you to use a paint gun (or spray paint) over rollers.

How do you set up a pegboard tool?

Hanging Your Garage Pegboard

  1. Step 1: Find and Mark Studs.
  2. Step 2: Measure Space for the Board on Your Wall.
  3. Step 3: Pre-drill Holes Through the Board and Wall.
  4. Step 4: Measure and Mark Space for the Bottom Frame Board.
  5. Step 5: Repeat for the Middle Board.
  6. Step 6: Mount the Pegboard to the Frame Boards.

Written by

Leave a Reply