Readers ask: How To Light A Pilot Light On A Wall Heater?

How do I light the pilot on my wall heater?

How to Turn On a Wall Heater

  1. To turn on your gas heater, locate the knob for starting.
  2. Turn the knob to “Pilot,” and then push down on the “Ignite” button.
  3. Once the pilot light comes on, hold down the Ignite button for 10 to 15 seconds.
  4. Set the temperature on the wall heater to your desired heating level.

Why does the pilot light go out on my wall heater?

Pilot Goes Out



The heater won’t operate properly if the pilot flickers, is too weak or goes out, and the cause could also be blockages in the pilot tube. Another cause of a weak pilot is a faulty thermocouple.

Can you manually light a pilot light?

Use a grill lighter or long match to light the pilot light valve at the bottom of the oven. Some ovens are designed to be manually lit at each use. In this case, slowly turn the temperature knob while holding the flame to the pilot light valve. Close the oven door after the pilot light ignites.

You might be interested:  Question: How To Put A Flat Screen Tv On The Wall?

Why is my wall heater not working?

If your heater’s not working at all, check for a tripped breaker or blown fuse. Reset the breaker or replace the blown fuse, if necessary. Remove the heater control knob, thermostat knob and faceplate to check for loose connections in these mechanisms. Tighten any loose wires.

Is it dangerous if your pilot light goes out?

Can a Pilot Light Outage Be Dangerous? The worry here is that when a pilot goes out, the gas valve that supplies the fuel for the pilot flame could still be pumping gas. This can mean a buildup of gas, and when the pilot is relit or relights itself it could result in a very serious explosion.

How do you relight an automatic pilot light?

How to Relight an Automatic Pilot Light

  1. Set the thermostat on your furnace to its lowest setting.
  2. Remove the access panel covering the gas control knob.
  3. Turn the gas control knob to the OFF position.
  4. Turn the gas control knob or knobs to the ON position.
  5. Turn the electrical power to the furnace back on.

How do you know if you have a bad thermocouple?

If you can‘t get the flame to light at all, and youre sure the gas is on, there’s probably an obstruction in the pilot tube. If the flame lights and goes out when you release the gas control knob after holding it in for the recommended 20 to 30 seconds, that’s the sign of a thermocouple malfunction.

Will gas leak if pilot light is off?

A pilot light is a small flame that is built into your gas heating appliances, such as a furnace or water heater. If the pilot light goes out for any reason, the current stops, the valve closes, thus preventing any gas from leaking.

You might be interested:  How To Remove Stickers From Wall Without Damaging Paint?

Can a pilot light cause carbon monoxide?

A yellow or orange pilot light will produce carbon monoxide – an odourless, colourless gas that can fill your home and cause carbon monoxide poisoning. Symptoms of this condition include dizziness, headache, fatigue, nausea, unconsciousness, brain damage and death.

Can I manually light my gas oven?

You can still manually light nearly every modern gas stove with a match or lighter, even if the igniter is broken. Matches are safer and will work better than typical cigarette lighters. Turn gas on medium. Light match.

Why won’t my pilot light stay lit on my hot water tank?

If your gas water heater doesn’t stay lit, you may have a defective control thermostat. The gas supply to the pilot assembly is controlled by this valve. If the pilot light won’t stay lit and the thermocouple is okay, then the thermostatic control valve may be defective.

How long does a wall heater last?

These heaters are expected to live for about 15 years but with proper care, can survive up to 30 years. However, as with any piece of gas equipment, you should have your wall heaters inspected annually.

Is it safe to leave a wall heater on all night?

Due to fire and safety concerns, portable heaters should not be left unattended. After use, they should be turned off and unplugged from the wall. Wall-mounted electric heaters have numerous safety features that make them both safe and reliable and can safely be left unattended.

Should the pilot light always be on in a gas heater?

Leaving the gas on keeps this compound moving out of the tubes. Keeping the pilot light on will also keep moisture out of the unit and in turn, help prevent corrosion. As you can see, it’s probably best in most cases to extinguish the pilot light in your gas fireplace during the months when you don’t need heat.

Written by

Leave a Reply