- 1 What goes between concrete slab and wall?
- 2 Can you pour concrete directly on dirt?
- 3 Do you have to put gravel down before pouring concrete?
- 4 How do I keep my concrete slab from moving?
- 5 Can you pour concrete next to existing slab?
- 6 Can you hammer a nail into concrete?
- 7 How do you secure a half wall on a concrete floor?
- 8 Should I put plastic under concrete?
- 9 Do you need rebar for 4 inch slab?
- 10 Is sand a good base for concrete?
- 11 How do you prepare the ground before pouring concrete?
- 12 Is quikrete as strong as regular concrete?
- 13 Is it cheaper to mix your own concrete?
What goes between concrete slab and wall?
Caulking is the process of filling in cracked concretes or the gap between slab and wall. Now, this is an efficient way of sealing the gap. A large gap can result in water getting into the cracks and making it even bigger. So you must caulk the gap to cover it up.
Can you pour concrete directly on dirt?
Long story short, yes you can pour concrete over dirt.
Do you have to put gravel down before pouring concrete?
Whether you pour concrete for a walkway or patio, a strong gravel base is required to prevent the concrete from cracking and shifting. Gravel is especially important in clay soil because it doesn’t drain well, which results in water pooling under the concrete slab and slowly eroding the soil as it finally drains.
How do I keep my concrete slab from moving?
Seal all open cracks and joints with a polyurethane or silicone caulk. Large gaps can be filled with a backer rod first and then caulked on top. Make sure downspouts are discharging at least five feet away from any concrete slab – the farther the better.
Can you pour concrete next to existing slab?
On the contrary, if your existing concrete is stable and elevating a few inches of its height won’t hinder anything in the way, then you can certainly get new concrete poured over the old one. But make sure to leave this to professionals since you don’t directly pour the layer of concrete.
Can you hammer a nail into concrete?
Concrete nails are made of hardened steel and have fluted shafts that help them sink into the concrete. Even with this heavier hammer, you will need to drill pilot holes for the nails. This is best done with a hammer drill and a masonry bit that is the same diameter or slightly smaller than the nails you‘re using.
How do you secure a half wall on a concrete floor?
Drill a 3/8″ hole through the floor plate with a standard wood bit, then, switch to a hammer drill with a 3/8″ masonry bit to drill at least a couple inches into the concrete. You want the hole to be deeper than the bolt by at least 1/2″ or more. This gives some space for the debris that accumulates at the bottom.
Should I put plastic under concrete?
Recently, though, research has shown that the old traditional layer of 6-mil Visqueen (polyethylene plastic) under the slab is seldom effective for two main reasons: Although it may seem water-tight, this grade of material allows a lot of water vapor to pass through.
Do you need rebar for 4 inch slab?
No, you do not need rebar for a 4–inch slab of concrete on grade. A 4–inch-thick slab cast on the ground and in permanent contact with it will float and rebar is not required. Rebar is recommended on concrete measuring 5 – 6 inches thick.
Is sand a good base for concrete?
Pour concrete over a solid, well-drained base
of sand or gravel over clay and other poorly draining soils to provide even support.
How do you prepare the ground before pouring concrete?
Preparation is the most important aspect of pouring a concrete slab.
- Dig the ground down to the proper depth.
- Smooth out the ground with the flat side of a rake so that you have a level surface.
- Tamp the ground with a hand tamper or mechanical tamper.
- Pour 2 inches of small, rounded gravel for additional drainage needs.
Is quikrete as strong as regular concrete?
Quikrete fast setting concrete is just as strong as regular concrete. Concrete gets its strength from a chemical reaction that occurs over time during curing. After it’s had time to cure, which usually take 28 days to complete, Quikrete can reach strengths up to 5000 psi.
Is it cheaper to mix your own concrete?
One of the least expensive ways to get concrete is to mix your own. You can buy bags of the mix from a home improvement store. Typically, you only have to add water for it to be ready to pour. Otherwise, you risk getting a weaker concrete once it cures, which could lead to cracks or crumbles within a couple of years.